PV Inverter-Controller Integrat
1．Using the sixth generation efficient IPM intelligent module from Japanese Mitsubishi, high efficiency and stable performance.
It with powerful protection function for short circuit, over load and over temperature which is more safe and reliable.
It's service life can up to 15-20 years or more.
2．Intelligentized, modularized and simple structure design, very easy and convenient for maintenance.
3．Two kinds of start mode: Step Down Voltage Start and Variable Frequency Start.
4．The output frequency 50Hz/60Hz can be set via LCD panel.
5．The output voltage can be set.
6．The DC input voltage range can be set. over-voltage point, under-voltage point, over-voltage recovery point, under-voltage recovery point and under voltage recovery time all can be set via the LCD panel.
7．Using SVPWM space vector algorithms, high conversion efficiency, high instantaneous power and low losses, higher efficiency > 94%.
8．Pure sine wave output. with good transient response less than 50MS, little harmonic distortion, higher conversion efficiency and stable output voltage.
9．Low frequency transformer, which ensure the AC busbar and DC busbar are completely isolated to avoid interference, high efficiency and very little no-load loss.
10．Powerful data display and fault instruction function. LCD can display the DC input voltage, output frequency, phase voltage, phase current, AC bypass input voltage, output power KWH, time and date, temperature, fault code display.
11．Wide input voltage can be set according to customer’s requirement. Input voltage range can be selected from 100-400v or 200-600v or 400-850v. This wide voltage input off grid inverter can work without battery and solar charge controller, which save battery cost and same like with MPPT function can maximum make full use of solar power .
12．AC bypass input function optional: Battery Power Priority or AC Bypass Priority work mode can be set.
13．RS485 remote monitoring function optional
14．Solar charge controller and AC to DC battery charger built in optional for customer
15．Can be customized to customer’s specification.
16．European CE (EMC and LVD) certification, accredited by Australian CEC, ERAC energy network, meet UL1741 and CSA22.2 standard.
1．Easy to repair: Mitsubishi IPM module structure structure design, very easy and convenient for maintenance.
2．Little fault rate < 1%
3．With low frequency transformer, 100% full power stable output
4．High efficiency > 92%
5．Long service life > 15 years
6．Setting flexible: input and output voltage, frequency can be set
7．Two kinds of work mode: VFD and step down voltage start
8．Big LCD display and fault code display
9．Certificate: SAA(AS4777&AS3100), CE(EMC&LVD), CEC.
Low Frequency Transformer
Rated voltage (Vdc)
Rated output power
Pure Sine Wave
3 phase 4 wire
7.6A (phase current)
50Hz or 60Hz
Rated output voltage range (V)
150%, 5 seconds
Waveform distortion rate (THD)
Dynamic Response (0 to 100% load)
Electrical insulation properties
2000Vac, 1 Minute
Input reverse polarity, under voltage, overvoltage, output over-current, short circuit, overheating etc.
No automatic recovery, need to restart the machine
Noise ( 1 meter)
Degree of protection
Depth* Width * Height